SME SERIES V

Mã sản phẩm: 1569

151,400,000₫

Mô tả sản phẩm

SERIES V

The work took almost four years and the measure of its success is the acceptance of the Series V precision pick-up arm by technical experts and users as one of the world’s truly great audio products. Series V sound has an almost startling dynamic range and neutrality enabling high levels to be enjoyed. It escapes the ‘LP’ sound and demonstrates that structural resonances in pick-up arms are responsible for much that makes vinyl records readily discernible from master tapes.

Series V Dimensions
A – Distance from pivot to stylus	233.15mm
B – Distance from pivot to turntable centre	215.35mm
C – Cartridge fixing centres	12.70mm
D – Offset angle	23.635°
E – Linear offset	93.47mm
F – Overhang	17.8mm
G – Height above mounting surface	max. 87.90mm min. 56.40mm
H – Height of record surface above mounting surface	max. 57.90mm min. 26.40mm
J – Depth below mounting surface	56.75mm
K – Radial clearance for balance weight	73.0mm
L – Clearance between cabinet lid and record surface assuming cartridge height at 17.0mm	35.0mm

ADDITIONAL INFORMATION

BUILD

Unique one-piece pressure die-cast tone-arm utilizing the advantages of magnesium, replace conventional fabricated construction.
Internally constrained layer damps minute residual vibration leaving the tone-arm acoustically inert. Finely machined cartridge platform, enamel free to avoid interface resonance.
A Stainless steel cross shaft, ground, and thread ground. Carried in massive yoke on 10mm ball races. Axis at record means level to minimize warp-wow.
Dynamic balance graduated vertical tracking force (VTF) control applies 0-3g x 0.125g through resonance controlled spring.
Unique assembly gives high rigidity and allows bearings to be critically adjusted before the tone-arm is fitted.
Stainless steel vertical shaft, ground and thread ground, with integral 16mm diameter flange to couple shaft and yoke.
23mm diameter steel pillar, heat-treated, ground, and honed, carries two 17mm ball races, widely spaced to resist tilt.

DAMPING

Anti-skate control operates through tension spring and filament. Dial corresponds with VTF and has a positive OFF position.
Lowering/raising control gives smooth positive action. The height of the lift can be adjusted.
Subsonic lateral mode fluid damper can be instantly adjusted or canceled.
The Dual-lock base provides movement control with high rigidity.
Swiveling damped output socket minimizes vibration transmission in sub-chassis use.

ADJUSTMENTS

Tungsten-alloy balance weight carried on damped two-point suspension. Extra-low inertia design assists warp riding.
Underslung weight housing corrects the center of gravity and provides non-reflective tone-arm termination. Adjustment leadscrew journalled in twin ball races with lever clamping.
Fine adjustment of arm height (VTA).
Reference lines on tone-arm facilitate VTA setting.
Fine adjustment of the horizontal tracking angle (HTA).

SPECIFICATION

Series V Specifications
Effective mass	10.0/11.0g
Cartridge balance range	4.2 – 18.0g
Vertical tracking force	0 – 3.0g(30mN)
Maximum tracking error	0.012(degrees per mm)
Null points	Inner 66.04mm Outer 120.90mm
Audio lead	Length 1.2m Capacitance 140.0 pF per channel Resistance 0.145 ohms per conductor
Internal wiring	Capacitance 15.0 pF per channel Resistance 0.5353 ohms per conductor
Output plug and socket	DIN 5-pole 240°
Weight net	720.0g